 |
To feed an IDS valve, choose from
our dispensing syringes, (to feed thin to
medium materials in very small shots) our
single cartridges, (for medium
to thicker materials in smaller shots) or one of our
reservoirs (for thin).
Pail dispensers, for thicker
materials. For a typical
valve setup,
click here.
|
|

Also in this Category:
1 LB Pressure Pot 1 Liter Pot 2 Liter Pot 1 Gallon Pot 2 Gallon Pot 5/10 Gallon Pot
Other Valves

You may also be
interested in:
Dispensers
Valve Controller
Dispense Valves
Reservoirs
Robot
Platform

Also of interest;
Precision Needles
Needle Nozzles
Thin Wall tips
Dispensing
Help
Doming & Potting
Solder Dispensing
|
|
To fill reservoir, simply remove
the lid, pour in your
(presumably thin) material and re-cover the pot.
Open the air shutoff valve at low pressure to supply air pressure on
the material, pushing it to the
valve chamber.
Using the air regulator, set the air pressure
to achieve the desired flow.
If the fluid delivery system is connected, open
your material shutoff valve to begin flow to place
dots or beads. Pressurization techniques do not
work with all materials, some may be too thick and will require a pump.
Features:
-
All Stainless Steel Reservoir
-
Teflon Encapsulated Viton O-Ring
-
Standard Viton Gasket in Material Filter
-
Rated for 190 PSI. Maximum Pressure
-
Quick Shutoff Valve for Supply Air Inlet
-
Standard, 0-60 PSI.
-
Air Regulator w/ Gauge
-
450 Micron Filter on Material Outlet
-
Shutoff Valve on Material Outlet
-
Optional Low Level Float Switch
Part #
Description
7011012 - 1
Gallon
Pressure Pot
7011013 - O-ring, Teflon Encapsulated Viton
for tank
|
|