The 1 Pound Pressure Pot
left, front left) is useful for a variety of fluids, especially
1 lb. bottles are
most common size for packaging CA. Side slit allows monitoring fluid levels without
opening. For UV, or light sensitive
fluids, choose the
1 Liter Pressure Pot, (shown
left, back right) which does not have side slit.
Also in this Category:
1 LB Pressure Pot
1 Liter Pot
2 Liter Pot
1 Gallon Pot
2 Gallon Pot
5/10 Gallon Pot
You may also be
Also of interest;
Thin Wall tips
Doming & Potting
To feed any IDS valve, choose from our
dispensing syringes, (to feed thin to medium materials in very small
(for medium to thicker materials in smaller shots or beads)
or for large
volume capacity, order one of our
reservoirs (for thin to medium
or one of our
dispenser units, for thicker materials. For a typical valve
setup, click here.
Simple to use:
two threaded thumbscrews and lift lid.
Place uncapped material bottle in center of tank.
Return lid to top of pressure tank, assuring dip tube is positioned inside
the bottle of fluid.
Connect all material and air lines supplying pressure to the tank.
Part # Description
3.25" diameter x 7.5" high
Dimensions: 6" diameter x 9.5" high
Body of Tank:
Anodized Aluminum, with side viewing slit
Gaskets: (2) Viton®
Pressure: 0-70 PSI
Air Inlet: 0.25" OD
tube quick connect fitting
0.125" NPT polypropylene fitting
7011007 - 1 LB CA Pressure Tank (Holds 500 g bottle of material)
7011008 - O-ring for tank,2 required
7011009 - Acrylic insert for tank