|
Do you want to use a pre-measured
package in a side by side kit?
The epoxy you are looking at may be
available in 1:1, 2:1, 4:1 or 10:1 ratios. If that is the case, you should be
able to use a dispenser that will be less capital cost but more expensive to
feed. The old adage is true - pay now or pay later. If your adhesive
manufacturer does not "down package" the material you need, IDS can do that for
you. Just click here.
Do you want to buy your materials in
bulk and save in the long run?
A meter mix and dispense
system is the answer for you. For small runs and precise shots, the
premixed/frozen syringe might be OK, but bipacks should be considered, too; they might be an excellent
solution for the standard 1:1, 2:1, 4:1 and 10:1 ratios in bi-packs, or side by
side cartridges.
Static-mixing elements afix to the cartridges. Luer-lock static-mixers are also
available for fine bead applications using luer-lock tips; note part numbers
with an “LL” suffix. if you use a Luer fitting, you can then use any of the IDS
Dispense Tips or
Needles.
Material
Viscosity (In Centipoise)
Water @ 70°F 1-5
Blood or Kerosene 10
Anti-Freeze or Glycol 15
Motor Oil (10) or Corn Oil 50-100
Motor Oil (30) or Maple Syrup 150-200
Motor Oil (40) or Castor Oil 250-500
Motor Oil (60) or Glycerin 1,000-2,000
Karo Corn Syrup or Honey 2,000-3,000
Blackstrap Molasses 5,000-10,000
Hershey Chocolate Syrup 10,000-25,000
Heinz Ketchup or Mustard 50,000-70,000
Peanut butter 150,000-250,000
Crisco or Lard 1,000,000-2,000,000
Caulking compound 5,000,000-10,000,000
Window Putty 10,000,000+
|
|
This section:
Dispense Finder
Dual Component
Meter/Mix/Dispense
Premixed/Frozen
Doming & Potting
You may also be
interested in:
Dispensers
Valve Controller
Dispense Valves
Reservoirs
Robot
Platform
|
