5900011-5LT-PKG = Manual Conformal Coating Spray System
SKU:
5900011-5LT-PKG
$5,560.00
$5,560.00
per item
SHIPPING COST INCLUDED IN PRICE - anywhere in the Continental USA that can receive UPS Ground shipments.
FULL SYSTEM PACKAGE - Specify round or flat spray cap when ordering.
The 5900011-5LT-PKG is a pistol grip mounted system which includes the 5900011R spray valve (round cap) unless otherwise specified. It is intended to be used manually. The pneumatic trigger handle to mount & activate valve uses 0-15psi and includes the atomizing air regulator with gauge assembly. The system uses the 7011010-L, 5-Liter bottle pressure tank assembly with air regulator & gauge. All fluid & air fittings & tubing to complete connections within system. Stand for valve & trigger handle while not in use.
Use to spray any low viscosity material, apply solvent based conformal coating or UV curable conformal coating to a circuit board, spray a masking material onto turbines before they are chemically treated, spray solvent onto a motor housing to clean and prepare the surface, spray light grease onto a bearing or race during assembly, spray flux.
Larger reservoirs are available. Contact an IDS representative for a quote. Requires regulated compressed air lines, up to 100psi. No electrical connection required.
REQUIRES A LINER - DO NOT DIRECT POUR. Most customers will use the bottle that the material comes in, set it directly inside, drop the feed tube in, and then pressurize.
Availability: 2 - 4 week build time. Need multiple units? Contact IDS directly for a quote. If you have never used this system with your material, be sure to confirm compatibility. Need this system automated? We can provide you with a quote for that. Contact IDS directly. This system is not intended for automation.
FULL SYSTEM PACKAGE - Specify round or flat spray cap when ordering.
The 5900011-5LT-PKG is a pistol grip mounted system which includes the 5900011R spray valve (round cap) unless otherwise specified. It is intended to be used manually. The pneumatic trigger handle to mount & activate valve uses 0-15psi and includes the atomizing air regulator with gauge assembly. The system uses the 7011010-L, 5-Liter bottle pressure tank assembly with air regulator & gauge. All fluid & air fittings & tubing to complete connections within system. Stand for valve & trigger handle while not in use.
Use to spray any low viscosity material, apply solvent based conformal coating or UV curable conformal coating to a circuit board, spray a masking material onto turbines before they are chemically treated, spray solvent onto a motor housing to clean and prepare the surface, spray light grease onto a bearing or race during assembly, spray flux.
Larger reservoirs are available. Contact an IDS representative for a quote. Requires regulated compressed air lines, up to 100psi. No electrical connection required.
REQUIRES A LINER - DO NOT DIRECT POUR. Most customers will use the bottle that the material comes in, set it directly inside, drop the feed tube in, and then pressurize.
Availability: 2 - 4 week build time. Need multiple units? Contact IDS directly for a quote. If you have never used this system with your material, be sure to confirm compatibility. Need this system automated? We can provide you with a quote for that. Contact IDS directly. This system is not intended for automation.
|
Have everything you need?
You may also require some of these products. Contact an IDS representative if you have any questions! |
